I’m looking to start keeping hardware for prints that need additional parts to complete them. A Pi case that I printed needed screws that I don’t have on hand and needed to go searching for some.

It got me thinking to keep a container of stuff ready that would get used often, but I don’t really know what to keep on hand. What do you have readily available?

  • EmilieEvans@lemmy.ml
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    DIN912

    DIN 7991

    small plastic screws

    square nuts

    GB91 (split pins)

    aluminium or copper tape (grounding/EMI-shield)

    conductive foam (EMI grommet)

    plastic glue (solvent) & cyanoacrylate

    • FleetingTit@feddit.de
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      I personally prefer DIN 7380 over DIN 912 aesthetically, but of course 912 has superior mechanical properties.

      • EmilieEvans@lemmy.ml
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        7380 do come in handy as you can buy them with a spring washer and washer pre-installed.

        If I care about aesthetics I use the DIN 7991 and dial in the tolerances to get it flush.