Hey folks, I’m toying with the thought of a portable, wireless/BLE, 34 key split kbd. Most builds that I’ve looked at hide the battery. Questions:

  • Do you mount the batteries? If so, where? Examples?
  • Does it in any way impact the portability?
  • Are there any other notable differences (in comparison to a wired board) one should be aware of?
  • DeltaWhy@keeb.lol
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    Some boards that use the nice!nano have room to tuck a small battery (I think 110mAh) underneath the controller. If they use the 3 middle pins on the nano though, that’s not an option. Rechargeable coin cells are an option, but for boards with the usual LiPO pouch cells, you’ll probably want some kind of case. Some folks just use double-sided tape to hold the battery to the PCB but I’d rather have some protection.

  • Skree@lemmy.world
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    Batteries require management with control circuitry normally on the MCU. This means you need to pick MCUs that support batteries.

    You will also want a on off switch for the battery somewhere.

    I always use LIR2450 button cell batteries where I can. The steel body makes them more resistant to damage where as pouch cells can’t take much of a scuff.

    They’re very portable! Just make sure the battery can’t be smushed if the board itself gets some pressure, and that it can’t get poked by sharp / conductive things.

    ZMK for the nice nano and XIAO nrf52840 should even report battery life! Your primary half (generally left) drains faster than the accessory half.

    RGB / screens that aren’t designed for low power are utterly destructive to battery life. I get ~1-2 weeks on 120mah splits. With RGB I’m lucky to get an hour.

    You don’t change these batteries as they’re rechargeable. Most boards will function while recharging. I offer QI wireless charging on my boards if you request it.