• viking@infosec.pub
    link
    fedilink
    English
    arrow-up
    48
    arrow-down
    2
    ·
    10 hours ago

    I agree with USB-C, but there are still a million USB-A devices I need to use, and I can’t be bothered to buy adapters for all of them. And a USB hub is annoying.

    Plus, having 1-2 USB-C ports only is never gonna be enough. If they are serious about it, why not have 5?

      • viking@infosec.pub
        link
        fedilink
        English
        arrow-up
        1
        ·
        2 hours ago

        It really is for me. Those things stick out way too far and might work alright in stationary mode, but while on the go they break easily (speaking from experience) and slip out all the time.

        • hemmes@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          3 hours ago

          An anti-top-shell design is aimed at preventing the accumulation of debris on the top surface

    • iopq@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      8 hours ago

      I bought some adaptors in China for around $0.50 each. It really isn’t that big of a deal

      • viking@infosec.pub
        link
        fedilink
        English
        arrow-up
        1
        ·
        2 hours ago

        It really is a big deal for me, they stick out too far and are making the whole setup flimsy.

    • Duamerthrax@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      arrow-down
      1
      ·
      9 hours ago

      You can’t buy a UCB-C Wifi dongle that last time I checked. You have to buy a c-to-a adapter, then use a usb-a wifi dongle. It’s nuts that those don’t exist.

      • Lemming421@lemmy.world
        link
        fedilink
        English
        arrow-up
        9
        ·
        edit-2
        8 hours ago

        Genuine question - what device do you have that has USB-C ports, no USB-A ports, doesn’t have WiFi, but supports the dongle?

        • Duamerthrax@lemmy.world
          link
          fedilink
          English
          arrow-up
          2
          arrow-down
          1
          ·
          7 hours ago

          Pinetab2 shipped with a wifi chip without any Linux drivers. The drivers eventually got made, but before that, you needed a USB dongle with Ethernet or a adapter.

          I would also like a USB-c wifi dongle for tech support reasons. Sometimes, the wifi hardware fails and you need a quick replacement to figure out what happened.

        • Krzd@lemmy.world
          link
          fedilink
          English
          arrow-up
          5
          arrow-down
          1
          ·
          8 hours ago

          Some applications need very specific drivers and protocols that aren’t compatible with normal chips. Or you have to connect to a device via WiFi but still need internet. Also long range WiFi antennas are amazing.

        • EngineerGaming@feddit.nl
          link
          fedilink
          English
          arrow-up
          2
          ·
          7 hours ago

          Maybe the preferred Linux distro doesn’t work with them. I had to use another distro for a while because Debian didn’t immediately support the card, but there are apparently cases where the internal card just permanently wouldn’t work (like in fully free software distros). I would rather replace the card inside the laptop than use a dongle, but idk islf this xan always be the answer.