Lol lol lol

I freeze it in bricks, lol, then bag the bricks.

Oh you’re good.

Yep. That helped!

260°C nozzle on the bed 225°C nozzle afterwards

Wow, that’s a huge difference between 1st layer and later! I’ve never seen that big a delta.

Drying helped. temp tower is next!

Nope. It’s led.

Nope. It’s led.

Technically correct.

Yes, exactly. The bottom of the stem is lower than the top of the pumpkin.

Plus I don’t like filament switching.

Lol

There’s a cereal bowl on the left if that helps.

Depends on how dense the board is. Infill is a choice when printing, so more plastic means more cost. I get my filament from $10 to $20 kg. Depends on sales and colors and such. These prints cost me $2 ish.

Theres a cereal bowl to the left. No bananas in it tho.

Desk knick knacks.

I wouldn’t do that in the slicer, it’s too hard to align them. I don’t know about any alignment tools in slicers. I could do that in Fusion360, however.

Good eye, bub.

Got them for free, other wise I wouldn’t. They’re also only 3 gallons, so a lot easier to handle. Haven’t tried them yet, but a porter is going in this weekend.

Check out some of the references! They were so flimsy.

None. It was store bought juice labeled apple strawberry banana.

Yes. There are several I’ve seen advertised but I’ve never used. Pcbway, despite the name, has 3d printing services. I have no experience with them.