Discover topics like diy, and the magic of the internet at Imgur, a community powered entertainment destination. Lift your spirits with funny jokes, trending memes, entertaining gifs, inspiring stories, viral videos, and so much more from users like jacobcoffinwrites.

This one was scratch-built as a gift. They wanted a shoe rack and sent me some links of examples for sale on amazon. The designs weren’t consistent, so I took what I felt were good features from each and built one from lumber I had.

Most of it was just pressure treated 2”x4”s someone on Everything Is Free had been looking to get rid of while cleaning out under his deck (these are the ones with thick, visible grain and a slight greenish tinge (always wear a dust mask while sanding but especially for these)) and older heat-treated 2”x4” whose origin I don’t remember.

The top section’s side plates and the supports for the lower shelf were cut from lengths of white-primed trim – these were edge-glued boards, meaning they were glued together from pieces of smaller scrap, and had zig-zaggy joints straight across the face of the lumber here and there. Because these joints are kind of ugly and not as strong as the regular wood, I cut sections from it that didn’t include them. Then I sanded off the white primer (wear a dust mask for this too) so I could stain them to match the rest of the piece.

The hardest part was finding something for the shelves themselves. I had a few thin lengths but not enough, and ended up posting to the Everything is Free page with a couple example photos asking if anyone had something close. Within minutes a guy offered up some bedrails he’d found on garbage day. He had taken them so they wouldn’t go to waste but didn’t have a project in mind and was happy to offer them up. I sanded them down smooth and cut them to length.

Wherever I can, I use wood screws as they’re much easier to remove than nails. But for a piece of furniture with very visible joints like this, I used finish nails almost everywhere. I also glued the joints as I nailed them so they wouldn’t work apart (this was especially necessary on the top, as the finish nails were thin brads and the slats liked to try to wander as I hammered others into place).

Once it was done, I treated it to the usual stain and polyurethane (both left over from previous projects, the stain I think was second-hand).

I was pleased with the final product - it’s surprisingly sturdy for something without any 45’s in the design - and the recipient liked it quite a bit, which is what matters.