• Vespair@lemm.ee
      link
      fedilink
      arrow-up
      22
      ·
      1 month ago

      Americans who drink hot tea have them (source: have had one for like 20 years).

      Americans in general are just more hot coffee cold tea people. Exceptions abound of course, but in generalities.

    • BananaTrifleViolin@lemmy.world
      link
      fedilink
      English
      arrow-up
      20
      ·
      1 month ago

      There is literally a kettle on the left lower side of the image (likely deliberately as it seems awkward having it in front of the air fryer like that)

      • affiliate@lemmy.world
        link
        fedilink
        arrow-up
        9
        ·
        1 month ago

        in my experience, it is quite hard to find a place for a kettle that isn’t at least a little awkward

    • janNatan@lemmy.ml
      link
      fedilink
      arrow-up
      8
      ·
      1 month ago

      I’ve heard electric kettles are slower here because of the limits of our electrical system. I do have a kettle for the stove, though. I also rarely drink tea.

      • dan@upvote.au
        link
        fedilink
        arrow-up
        8
        ·
        edit-2
        1 month ago

        Standard outlets in the USA are 120v at 15A (1800W max peak, 1440W max continuous). In comparison, standard UK outlets are 230v at 13A (2990W peak)

        This also affects other things. For example, standard electric heaters (resistive heat) can’t get as hot in the USA.

        Edit: Also, dryers in countries like UK and Australia don’t need a special type of outlet.

        • Ross_audio@lemmy.world
          link
          fedilink
          arrow-up
          3
          ·
          1 month ago

          Due to a quirk of unifying 2 standards, Europe and the UK, the range is 216.2 volts to 253.0 volts.

          That encompasses infrastructure built to a tighter tolerance around 220V in Europe and infrastructure built to a tighter tolerance around 240V in the UK (and Australia).

          We expect 3150W out of a kettle most of the time. Our heaters will say 3kW.

          Usually you’ll find a few volts over 240 out of our outlets and that’s to design spec.

          • dan@upvote.au
            link
            fedilink
            arrow-up
            1
            ·
            edit-2
            1 month ago

            Thanks for the info! I’ve never actually lived in the UK so I was just guessing based on what I’ve read online.

            I was going to use Australia as an example (since I was born there) but standard outlets in Australia are only 10A so they’re not quite as powerful as the UK ones :). There’s 15A outlets but they’re not very common.

      • jdeath@lemm.ee
        link
        fedilink
        arrow-up
        5
        arrow-down
        1
        ·
        1 month ago

        my electric kettle takes maybe 20 seconds to get to boiling water here in the USA

      • nixcamic@lemmy.world
        link
        fedilink
        arrow-up
        3
        ·
        1 month ago

        My friends just put a euro style 220 outlet on their counter and ordered a kettle online. Since they were building the house new it was basically no different than buying a 110v kettle.

          • Revan343@lemmy.ca
            link
            fedilink
            arrow-up
            4
            ·
            1 month ago

            American wiring is center-tapped ~240V; typical 120V outlets are from line on either side of the tap to the neutral, while dryers, stoves, etc. are 240V line to line. So they would have wired it like a stove, but then put in a euro style plug instead of a stove plug

          • nixcamic@lemmy.world
            link
            fedilink
            arrow-up
            3
            ·
            edit-2
            1 month ago

            You just run 220 from the panel to it. Almost every US house has 220 outlets for the dryer and stove anyhow. All you’re doing is using a different shaped plug, and like, wires are wires, they fit into a euro plug the same as they fit into a NEMA plug.

          • socsa@piefed.social
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 month ago

            Technically it wouldn’t be to us code. It would be way smarter to just install a NEMA outlet and use an adapter, or even better just replace the plug on the kettle.

            • nixcamic@lemmy.world
              link
              fedilink
              arrow-up
              1
              ·
              edit-2
              1 month ago

              I don’t actually live in the US, just somewhere that happens to use 110 and NEMA outlets.

              Also I think the theory with the euro plug was that when the kettle died they could just buy another and not have to modify anything.